FULLY RECESSED DIE CAST ALUMINUM EXIT SIGN -- SINGLE FACE

PRODUCT OVERVIEW

The CX Series Fully Recessed Die Cast Aluminum LED Exit combines a fully recessed design, the latest in die casting technology and high performance electronics to ensure reliability. The installed recessed sign blends nicely with all modern interiors.

ILLUMINATION

Illumination of the exit stencil face is accomplished with long lasting, high output Light Emitting Diodes (LEDs). Hot spots and striations are eliminated by a combination of indirect and direct aiming points covering the exit stencil face.

HOUSING

Three-piece die cast aluminum construction with NFPA-type field selectable chevrons. Housing and stencil face castings are available with durable epoxy-based powder coat paint finishes. A brushed aluminum stencil face is also available. A positive latching exit stencil face provides secure closure yet is easily accessible for installation, maintenance and inspection. Vandal resistant versions include tamper resistant hardware and a .08in thick polycarbonate protective lens mounted outside the exit stencil.

RECESSED FRAME

The 20 gauge galvanized steel mounting frame utilizes an easy to adjust drywall clamping bracket which can accommodate wall thicknesses from 1/4in to 3/4in. Conveniently located knockouts in the rear housing can accommodate direct connection to a junction box. A centrally located 1/4in knockout is available for connection to a 90 degree Bx cable connector. The recessed mounting frame kit is ideal for applications requiring low level exit signage. When used in conjunction with the vandal resistant lens (VR option) and tamperproof lockup (TP option), the CX Series Fully Recessed Die Cast Exit can be located in high abuse areas.

VANDAL RESISTANT OPTIONS

The CX Series incorporates an optional .08in thick polycarbonate lens externally mounted. Tamperproof screws fully secure the exit from unwanted entry.

ELECTRONICS

AC Only and Self-Powered
Dual voltage 120/277 VAC input with surge protection is standard.

Self-Powered
All components are located within the exit housing. An indicator light is located on the stencil face to signify that AC utility is present. AC lockout prevents battery drain prior to the initial energizing of utility power. The low voltage disconnect (LVD) feature will disconnect the battery prior to an unacceptable deep discharge, but not before the required 90 minute emergency operation. The brownout protection circuitry will automatically switch the unit into the emergency mode if the utility voltage sags below 20% of nominal. Battery charging circuitry is entirely solid-state, and of a constant current design. Battery recharge time after a complete discharge is less than the required UL 924 standard. Solid-state circuitry causes an instantaneous transfer to battery power if either the loss of AC utility, or a brownout condition is detected. When line voltage is present and stabilized, the transfer circuitry switches back to normal operation and begins recharging the battery. The transfer circuitry can be tested via a momentary test switch located on the bottom of the housing.

ELECTRICAL SPECIFICATIONS

Input power requirements at 120 VAC

AC Only

Red - 3.32 watts

Green - 4.11 watts

Self-Powered

Red - 4.39 watts

Green - 3.52 watts

CODE COMPLIANCE

UL 924 listed

NFPA 101, NEC, BOCA and OSHA standards

BATTERY

A maintenance free, sealed nickel cadmium battery is standard. Construction is of the sintered plate design and the battery assembly is equipped with a quick connect plug assembly for easy installation. Standard sustained emergency operation is for 90 minutes with the LED illumination source providing full light output. Extended run times are available as an option. The suggested operating temperature range of 20°F (-7°C) to 95°F (35°C) and should provide a service life of 10 years.

WARRANTY

Three year full electronics warranty

Five year full, 5 year prorated battery warranty

ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.