5.0
Flame Spread – either one of the following two standards:
5.1
ASTM E 162-2002, Standard Test Method for Surface Flammability of Materials
Using a Radiant
Heat Energy Source.
5.1.1
Four test specimens (of each distinct product material) shall be tested in
accordance with
ASTM E 162. Where the test specimen is narrower than required by the test, several
pieces may be grouped together to provide the necessary surface area. Thin gauge
films and paints shall be tested when applied to a rigid cement board ¼"
thick.
5.1.2
The specimens shall have a flame spread index (ls) not to exceed 35.
5.2
ASTM D 635-2003, Standard Test Method for Rate of Burning and/or Extent and
Time of Burning
of Plastics in a Horizontal Position.
5.2.1
Ten test specimens shall be prepared for use in accordance with ASTM D 635.
5.2.2
The test specimens shall not burn beyond the 25 mm reference mark.
EXCEPTION:
For photoluminescent products that,
when installed, provide coverage exceeding the limits
of interior trim, such products shall instead be tested for flame spread and
smoke density as interior
finishes and/or interior floor coverings if and as required by Building Code "
27-348(c) and (d)
and/or " 27-351. Tread nosings with a horizontal depth of 4? or less and that
contain a photoluminescent
stripe may be tested in accordance with RS 6-1A.
NYC Law 26 Section 4 PREVIOUS PAGE
NYC Law 26 Section 6 NEXT PAGE